Lbl-lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v User Manual download pdf

Installation Instructions for

1.3

TRANS-SFM500-2-_

980MR2SFM50SMT

12 Volt 500 Watt Single Power Feed

Magnetic Surface Mount Transformers

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage magnetic

applications may work initially, but could eventually cause

transformer failure and will void the warranty.

The dimmer must be

derated as indicated by the dimmer manufacturer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load each circuit of the surface mount transformer to no more

than the maximum rated capacity as specified.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

2-Circuit Monorail

1 2 3 4

Summary of Contents

Page 1 - Important Safety Information

Installation Instructions for1.3TRANS-SFM500-2-_980MR2SFM50SMT112 Volt 500 Watt Single Power FeedMagnetic Surface Mount TransformersGP I :ENERAL RODUC

Page 2 - Adjust the Power Feed Height

33"36"METAL TUBE2Adjust the Power Feed HeightLoosen the two M3 set screws on power(Do Not Remove)feed housing and one M3 set screw on plasti

Page 3 - Install the Transformer

POWER FEEDHOUSINGMETAL TUBE3/4"OUTER WRAPPED WIREINNER WIRE3Feed the power feed cord through power feed housing and themetal tube (included in th

Page 4 - SAVETHESE INSTRUCTIONS!

Hook the transformer safety wire onto the backplate bracket.Connect the backplate to a suitable ground in accordance withlocal electrical codes.For ea

Comments to this Manuals

No comments

Lbl-lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v User Manual

Browse online or download User Manual for Lighting Lbl-lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v. LBL Lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Lbl-lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v