Lbl-lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v User Manual download pdf

Installation Instructions for

12 Volt 600 Watt Dual Direct Power Feed

Magnetic Surface Mount Transformers

1.4

TRANSDIR-SFM600_

980MRLDDFM60SMT

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage magnetic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load each circuit of the surface mount transformer to no more

than the maximum rated capacity as specified.

Monorail

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 2 3 4

Summary of Contents

Page 1 - Important Safety Information

Installation Instructions for12 Volt 600 Watt Dual Direct Power FeedMagnetic Surface Mount Transformers1.4TRANSDIR-SFM600_980MRLDDFM60SMT1GP I :ENERAL

Page 2 - Install the Transformer

2Loosen the three #8-32 flat head screws(Do Not Remove)with the provided 3/32 Allen wrench.Rotate the backplate counter clockwise so that the #8-32 fl

Page 3 - 1A2A 1A2C

3Connect the Monorails to TransformerPush two Monorail sections completely onto the straightisolating connectors.Tighten the M3 set screws firmly with

Page 4 - SAVE THESE INSTRUCTIONS!

Comments to this Manuals

No comments

Lbl-lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v User Manual

Browse online or download User Manual for Lighting Lbl-lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v. LBL Lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Lbl-lighting MO Direct Feed Surf Mag Xfmr 600w 120v/12v