Lbl-lighting LED Illum MO Direct Feed Surf Mag Xfmr 300w 277v/1 User Manual

Browse online or download User Manual for Lighting Lbl-lighting LED Illum MO Direct Feed Surf Mag Xfmr 300w 277v/1. LBL Lighting LED Illum MO Direct Feed Surf Mag Xfmr 300w 277v/12v User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Installation Instructions for
12 Volt 300 Watt Single Direct Power Feed
Magnetic Surface Mount Transformers
1.2
TRANSDIRSFM300SC-LED_
980MRLDSFMT30SMT-LED
1
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed only when all the products used are
supplied by LBL Lighting, is suitable only for indoor dry locations
and approved for use at any height above the finished floor.
A typical installation is shown. Specific installation must be in
accordance with local electrical codes.
This product may be dimmed only with a low voltage magnetic
dimmer. Using a dimmer not designed for low voltage magnetic
applications may cause undesirable noise and potentially shorten
the life of the transformer.
This product is intended for use with LBL Lighting low voltage
lighting systems only.
Read all instructions thoroughly. Read "Important Safety
Information" on next column before proceeding with the
installation.
Important Safety Information
Do not conceal or extend bus bar conductors through a building
wall.
Do not install this lighting system in a damp or wet location.
To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.
Do not install fixture assemblies closer than six inches to curtains
or similarly combustible materials.
Turn the electrical power off before modifying the lighting system in
any way.
The fixtures used with the system must be identified to be used
with the corresponding system.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
Load the circuit of the surface mount transformer to no more than
the maximum rated capacity as specified.
LED-Illuminated Monorail
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Important Safety Information

Installation Instructions for12 Volt 300 Watt Single Direct Power FeedMagnetic Surface Mount Transformers1.2TRANSDIRSFM300SC-LED_980MRLDSFMT30SMT-LED1

Page 2 - Install the Transformer

2Install the TransformerLoosen the three #8-32 flat head screws(Do Not Remove)with the provided 3/32 Allen wrench.Rotate the backplate counter clockwi

Page 3 - Monorail to the Transformer

3Connect the LED-IlluminatedMonorail to the TransformerRemove the power feed cap from the power feed housing.Completely back out the screw on the powe

Page 4 - SAVETHESE INSTRUCTIONS!

4SAVETHESE INSTRUCTIONS!7400 Linder Ave, Skokie, IL 60077800.323.3226 - 847.626.6300www.lbllighting.com© 2014 LBL Lighting.All rights reserved.The &

Comments to this Manuals

No comments