Lbl-lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/1 User Manual download pdf

Installation Instructions for

1.3

TRANSDIR-SFM500-2-_

980MR2DSFM50SMT

12 Volt 500 Watt Single Direct Power Feed

Magnetic Surface Mount Transformers

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage magnetic

applications may work initially, but could eventually cause

transformer failure and will void the warranty.

The dimmer must be

derated as indicated by the dimmer manufacturer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system

in any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load each circuit of the surface mount transformer to no more

than the maximum rated capacity as specified.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

2-Circuit Monorail

1 2 3 4

Summary of Contents

Page 1 - Important Safety Information

Installation Instructions for1.3TRANSDIR-SFM500-2-_980MR2DSFM50SMT112 Volt 500 Watt Single Direct Power FeedMagnetic Surface Mount TransformersGP I :E

Page 2 - Install the Transformer

2Install the Transformer#8-32 FLATHEAD SCREWBACKPLATE3/32 ALLENWRENCHHOUSINGLoosen the three #8-32 flat head screws(Do Not Remove)with the provided 3/

Page 3

3Connect the 2-Circuit Monorail tothe TransformerTighten the screw on the power feed cap for proper powerconnection.Tighten the knurled cap for proper

Page 4 - SAVE THESE INSTRUCTIONS!

Comments to this Manuals

No comments

Lbl-lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/1 User Manual

Browse online or download User Manual for Lighting Lbl-lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/1. LBL Lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/12v User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Lbl-lighting 2-Circuit MO Direct Feed Surf Xfmr Mag 500w 120v/1