Lbl-lighting Tubes 7 SP User Manual download pdf

1B 1D

Installation Instructions for

Tubes Seven

1.0

HS72932/1FR_1B35

980TUBES7SP

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor dry locations only.

This product can be dimmed with a standard incandescent dimmer.

Install the Canopy

#8-32 SCREW

MOUNTING PLATE

CANOPY HOUSING

Remove the three #8-32 screws on the sides of the canopy

housing.

Lift the mounting plate out from the canopy housing.

MOUNTING PLATE

With a hammer tap the anchors at the marked points into the

ceiling up to the threaded portion.

Screw the anchors in the rest of the way with a Phillips

screwdriver.

ANCHOR

Feed the power line wires through the mounting plate

center hole.

Line up the two mounting plate slots with the electrical box

holes and use the two provided #8-32 screws to mount it to

the electrical box.

#8-32 SCREW

Align the mounting plate holes with the electrical box holes

and mark four points onto the ceiling through the mounting

holes.

MOUNTING

PLATE HOLE

Suspension

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

3 3

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Tubes Seven

1B 1D1CInstallation Instructions forTubes Seven1.0HS72932/1FR_1B35980TUBES7SPGP I :ENERAL RODUCT NFORMATIONThis product is suitable for indoor dry loc

Page 2

1H1F1E 1G82Secure the mounting plate to the anchors with the provided#8 screws.#8 SCREWSAFETY CABLEInsert one end of the safety cable into the mountin

Page 3 - Assembling the Fixture Arms

3(H)Assembling the Fixture ArmsThe overall fixture height (H) is measured from bottom of thebottom glass shade to the end of the fixture Fusion Jack.D

Page 4 - ASSEMBLY ROD

4Insert the fixture rods into the Fusion Jack assembly rod, makesure the fixture rods are aligned with the top of the FusionJack assembly rod.Tighten

Page 5 - Install the Lamp

5Install the LampFor each socket, loosen the two M3 sets(Do Not Remove)screw with the 1.5 MM Allen wrench.SOCKET1.5 MM ALLENWRENCHM3 SETSCREW1.5 MM AL

Page 6

1476523From between the fixture rods, carefully place a glass shadeonto each socket assembly.Repeat steps 1 through 3 to install the lamp for the rema

Page 7

Page 8 - SAVETHESE INSTRUCTIONS!

Comments to this Manuals

No comments

Lbl-lighting Tubes 7 SP User Manual

Browse online or download User Manual for Lighting Lbl-lighting Tubes 7 SP. LBL Lighting Tubes 7 SP User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Lbl-lighting Tubes 7 SP