Lbl-lighting MO Rmt Elec Xfmr 150w 120v/12v LED User Manual download pdf

Installation Instructions for

120 Volt to 12 Volt DC Single Feed 150W Remote

Electronic Transformers

950RM15012EL

GP I :ENERAL RODUCT NFORMATION

This transformer is ETL listed for use with low voltage lighting

systems of brands offered by Encompass Lighting Group.

This product is suitable only for indoor dry locations and

approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with the local electrical codes.

This product may be dimmed only with a low voltage

electronic dimmer. Using a dimmer not designed for low

voltage electronic applications may work initially, but could

eventually cause transformer failure and will void the warranty.

The dimmer must be derated as indicated by the dimmer

manufacturer.

This product is intended for use with Encompass Lighting

Group brands of low voltage lighting systems only.

During installation, make sure all power connections are tight.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a

building wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can

be shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to

curtains or similarly combustible materials.

Turn the electrical power off before modifying the lighting

system in any way.

The fixtures used with the system must be identified for use

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches

(98 cubic centimeters).

To Reduce Risk of Fire, it is important to wire the remote

transformer for the system as described in this installation

instruction.

Load the circuit of the remote transformer to 150MAXIMUM

Watt.

TRANSFORMERS

CAUTION: RISK OF FIRE

This product requires installation by qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

1.0

1.2

1 2 3 4

Summary of Contents

Page 1 - Important Safety Information

Installation Instructions for120 Volt to 12 Volt DC Single Feed 150W RemoteElectronic Transformers950RM15012ELGP I :ENERAL RODUCT NFORMATIONThis tran

Page 2

CONDUIT2Install the Remote TransformerTRANSFORMERCOVERPHILLIPS SCREWRemove the four Phillips screws to remove thetransformer cover.Secure the transfor

Page 3 - LOW VOLTAGE WIRE SIZE TABLE

CONDUITLOW VOLTAGEWIRES3Install a conduit from the transformer to the electricalbox.For the best performance, use the "Low Voltage WireSize Table

Page 4 - SAVE THESE INSTRUCTIONS!

4TRANSFORMERCOVERPHILLIPS SCREWConnect the 120 volt power line wires at the panel.After installing the entire system, operate the system forfive minut

Comments to this Manuals

No comments

Lbl-lighting MO Rmt Elec Xfmr 150w 120v/12v LED User Manual

Browse online or download User Manual for Lighting Lbl-lighting MO Rmt Elec Xfmr 150w 120v/12v LED. LBL Lighting MO Rmt Elec Xfmr 150w 120v/12v LED User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Lbl-lighting MO Rmt Elec Xfmr 150w 120v/12v LED